Hot Tub Disposal

Hot Tub Disposal

Draining and Electrical Disconnection

Pumping out the water into the foul drain, letting sanitiser levels fall first, and safely isolating plug-in or hardwired electrics before removal.

Free Hot Tub Disposal quote

No obligation. We only use your details to reply about this job.

A wooden hot tub outside a stone building

What's involved

A full hot tub holds roughly 1,000–2,000 litres of water. We use a submersible pump to drain it, directing the hose into a foul water drain, such as an outside gully that connects to the sewer, rather than a surface water drain that runs straight to streams. Ideally, stop adding chlorine or bromine a few days beforehand so the levels drop. Pumping out usually takes 30–60 minutes, and we sponge out the last few litres from the footwell. Plug-and-play tubs on a 13 amp supply are simply unplugged. Hardwired tubs on a 32 amp or larger supply have a dedicated isolator and RCD, and the cable should be disconnected and made safe by a competent electrician, which we can arrange. Never cut a live cable. If the tub has been empty for a while, rainwater and leaves may need clearing before the shell can be lifted.

How we handle it

  1. Send photos and measurements

    Tell us the tub type and size, and send photos of the tub and route out, plus the width of gates and paths. Say whether it is plug-in or hardwired and if it still holds water.

  2. Get a fixed price and plan

    We confirm whether the tub can go out whole or needs cutting, how long it will take and the crew needed, and send one fixed price.

  3. Prepare the tub

    Stop adding sanitiser a few days before. If the tub is hardwired, arrange for an electrician to disconnect it, or ask us to arrange one. Clear the route of pots and furniture.

  4. Drain and remove

    Our team pumps out the water to a foul drain, then removes the tub whole on dollies or cuts it into sections, protecting lawns and paving with boards.

  5. Clean up and recycle

    The area is swept and cleared. Pumps and controls go for WEEE recycling, and other materials to appropriate routes. You receive a waste transfer note.

Price guide

Hot tub disposal is priced on the size and type of tub, whether it can go out whole or must be cut up, and access to your garden. A drained plug-and-play tub with a wide side gate is the simplest job. Swim spas, cut-ups and tubs behind houses with no side access cost more.

  • Swim spa removal: from £900. By breakdown or crane lift; priced after photos or a site visit.
  • Cover, steps and gazebo removal: £40–£250. Depends on what needs clearing, from a single cover to a full gazebo and decking surround.
  • Inflatable hot tub: from £50. Liner, pump unit and accessories collected; pump recycled as electrical waste.

Questions about draining and electrical disconnection

How do I drain my hot tub?

Switch off the power, then use the drain valve or a submersible pump to empty the water into a foul water drain connected to the sewer, not a surface water drain. Stop adding chlorine or bromine a few days before so levels drop. Sponge out the last water in the footwell before removal.

Do I need an electrician to disconnect my hot tub?

Plug-and-play hot tubs on a 13 amp plug can simply be unplugged. Hardwired tubs run on a dedicated supply, usually 32 amps or more, with an isolator and RCD. Disconnecting these should be done by a competent electrician, who will make the supply cable safe. We can arrange this as part of the removal.

How wide does a gate need to be to remove a hot tub?

A typical hot tub tipped on its side is about 90–100 cm deep, so you usually need a clear gap of around a metre, plus room to manoeuvre around corners. Measure the narrowest point on the route, including gates, side passages and between walls. If it is too narrow, the tub will need cutting up.

Get a free hot tub disposal quote

Tell us what you need and we'll come back with a clear price.

Request a quote